![]() |
SUPER RADIAL ANCHOR SEAL KIT FOR REPAIR OF |
TUBELESS TYRES |
|
|
|---|---|
Steps to use SRAS Kit |
![]() |
![]() |
![]() |
| Locate and mark injury and determine direction of puncture. Carry out repairs only within marked repair area (tread) upto max. repairable damage of 6mm. | Dip the ratchet reamer into the special cement BL, then introduce the cutting tool into the perforation by permanently turning it clock-wise and clean the perforation carefully. Keep on turning clock-wise while pulling back the cutting tool. | Hook the repair plug into the inserting tool. Proceed as follows : Holding the inserting tool with the eyelet opening upwards, introduce the repair plug and pull on its free end, until the plug is located at the end of the eyelet. |
![]() |
![]() |
![]() |
| Unlock the retractable by pressing with the thumb and open fully. Fit the free end of the plug into the tenter hook and close retractable handle again. | Dip the inserting tool with retractable handle closed and the plug stretched into the special cement BL. Insert the tool immediately without turning, into the perforation upto the handle. | Activate locking pin - the repair plug is released and well seated in the tyre. |
![]() |
||
| Remove inserting tool immediately without turning it. Inflate the normal service pressure and cut off excess end of . Finally check repair for airtightness |
Tip
Top General Agencies Private Limited
80/1, Block
II, WHS Kirti Nagar, New Delhi - 110 015 Tel :
91-11-5153714 , 5118465 Fax : 91-11-5153716
e-mail: info@rematiptopindia.com